MatrikonOPC Server for SCADA CAC
|
|
|
|
| |
| |
This MatrikonOPC Server provides connectivity to any eProductions 8500 or 8550, or any Baker 8500 or 8550 compatible RPC (Rod Pump Controller) device via the 8500 Comm Protocol. The MatrikonOPC sever is installed on a Windows PC and connects to multiple devices at a time using SCADA interfaces.
The MatrikonOPC Server includes support for:
- Multiple communications channels at the same time (serial, radio, network, dial-up)
- Supervisory control using single-destination and broadcast commands
- Redundancy, including channel redundancy, and fail-over and fail-back
- Round-Robin polling
- Detailed polling schedule
- Optimized for low-bandwidth and noisy communication channels
- Runs as a Windows Service
|
|
| |
|
| | - Tag Browse Capable
- Configurable Time-Out
- Redundancy
- Supports Telemetry Scada
- Supports Multiple Data Sources
|
|
|
|
| |
| | Cables: Ethernet; Serial RS232 |
OPC Specifications
| |  OPC DA (OPC Data Access) 1.0a | | | OPC DA (OPC Data Access) 2.0 | | | OPC DA (OPC Data Access) 2.05a | | | OPC DA (OPC Data Access) 3.0 |
|
System Requirements:
| | PC Hardware | | | | The following PC Hardware is required:
Intel® Pentium® 4 Processor
512 MB RAM
Minimum 32 MB of available hard disk space
CD-ROM driver
Super VGA (800 × 600) or higher-resolution monitor with 256 colors
Mouse pointing device |
| | PC Software | | | | The following Windows Operating Systems will support this OPC Server:
Windows 2000
Windows XP
Windows 2003
Features Include:
Support for DDE
Aliases for tag names
Calculation engine |
|
|